A dozen or so DS-2CD27332F-IS HikVision cameras. All installed on a remote computer. All with Ports @ 80. All with RTSP ports @ 8450. All with local device ports @ 8000-8015, one port for each camera. A PCNVR, version 1.03.06.02 on the same remote computer with all the cameras locally added and working. HTTP Port @ 80. RTSP Port @ 8450 Nor can I get live view to work on the two new cameras when going to their IP. I could however get Live View to work when going straight to my older 3x cameras and have full control/config on them. With SADP via LAN port on the NVR I can 'see' all cameras and IP addresses are correct/valid. I have (finally!) got Live View on NVR to work by Accessed Hikvison via IP Address. Navigated to Configuration Tab. Then clicked Local. Re-entered Encryption Key, in my case default 123456. Clicked Save. Back to camera views and clicked Play in Live View. Had set to Mainstream and after 20 seconds or so SUCCESS ! tj. alastairstevenson. How to fix the issue with Hik-connect not displaying all the cameras. Let's take a look at some possible solutions for the problem. Check the network status; Adjust the Hik-Connect bitrate settings; Change the user's privileges; Update the Hik-Connect phone app; Remove and re-insert the cameras. you will be able to live view or playback from the DVR/NVR. Live View Click the Live View tab to open the Live View page. On the Live View page, you can view the live video of the added cameras and do some basic operations, including picture capturing, manual recording, PTZ control, etc. Steps: Tap on the live view page to enter the quality switching panel.; Note: The icon may vary according to the actual video quality. Tap Custom to enter the customized panel as shown below.; Configure the parameters according to actual needs, including Stream Type, Resolution, Frame Rate and Bitrate. Tap Confirm to save the settings.; Note: The live view effect is related to the performance sTMXM.

hikvision live view not working